> Terms of Use     

HOME PRODUCTS TRACEABILITY Friendly LINK OVERSEAS AGENCY

HOME > PRODUCT Top > Traverse controller

TRAVERSE CONTROLLER (TRC-10)

Data Printers
  • TRAVERSE CONTROLLER (TRC-10)
    This is a device to control Traverse motion of Winding drum.
    This device is to output Traverse speed voltage in proportion to its pulse
    frequency number through receiving a rotation pulse of winding drum.

Specifications


Type Traverse Controller
Model TRC-10
CAD file dxf      pdf
Summary This controller can control traverse motion when widing up
cables to cable drum. Control output is proportional voltage to
widing up speed.
Display Position/Setting, State(RUN/WAIT), Direction
Data setting Drum width, Pitch, Stop angle, Max. speed,
Pulse rate, Output fine adjustment
Volume setting Wide movement value, Frame movement value
Pulse input A/B Phase(0.01 - 50kHz), Single phase pulse available,
DC+12V[Max.40mA] Power supply avaelable
Extrenal input Quick feed, Wide movement, Position reset, Frame movement,
Emergency stop, Turn, Normal traverse, Reverse traverse start
Traverse output Max.+/-10VDC(Resolution : 12 bits)
Fixed voltage
output
+/-10VDC 2 channel, DC0 - +10V 2 channel
(Adjustable by volume at rear panel)
Contact output A direction, B direction
AC250V/DC30V 10A DC30V (Resistance load)
Power supply AC100 - 240V 50/60Hz 5VA
Ambient
condition
Temperature:0 - 45degree centigrade,
Humidity:35 - 85%RH(No condensation)
Outside
dimension
144(W) * 72(H) * 191(D)[mm]
Weight Approx. 1.5kg


[Go to top this page]

[Back]